Prerequisite:

9129-808-111             Snom-EHS Box  ( bei Snom erhältlich )

Snom 320 / 360 / 370

(**Snom 370 > ab Software 7.1.28

Connection:

2) Connect the Snom EHS box to the " EXT " socket of your Snom instrument and the " AUX" interface of your 9120 basestation.

Software setting:

The 9120 must be set for DHSG Software
(The 9120 EHS is always supplied in DHSG mode.)

To check the installed software,proceed as follows:

Plug the headset into the basestation and press the PLUS and MINUS button simultaneously
for about 6 seconds until the online display on the headset starts to flash.

Now your current software is displayed on the basestation.

The radio lamp displays RHL; the MUTE-LED DHSG and the accumulator display AEI.

With the aid of PLUS and MINUS button you can toggle between different kinds of software.

Installation of the software is confirmed when after about 10 seconds the base station again automatically changes over to the charge state

Base setting:

Set the telephone setup switch ( A-G ) at the position "A".

Adjustment of the transmission volume :

With the headset please make a call . .

Nowt both the PLUS and MINUS button on the headset must be pressed simultaneously and immediately a beep is heard.

Now with the aid of the PLUS button you can increase the volume of the microphone or alternatively with the aid of MINUS button you can reduce it.

This is confirmed by a slight beep heard in the headset after about 5 seconds. The settings are subsequently automatically saved.