Open Phone 63 / 65 + AZ adapter + DE-EHS-001
EQUIPMENT
Open Com 100 starting at Software 5.2
Open Com 1000 starting at Software 3.2
Connection:
Connect the 4-pin RJ10 connection cable supplied to the socket labeled with a "telephone symbol" on the GN 9120 base station and the other end to the AZ adapter's "headset plug socket" .
Now insert the DE-EHS-001 connector cable 8-pin RJ45 jack into the "AUX" plug socket on the GN 9120 base station.
Please connect the low-voltage connector to the AZ adapter's plug socket labeled with the "bell symbol" and insert the 6-pin modular connector into the AZ adapter's "plug socket for second receiver" .
Software settings:
The GN 9120 must be set to RHL software.
(The GN 9120 DHSG is always delivered in DHSG mode).
You can check and/or set it as follows:
Place the headset on the base station and press the PLUS and MINUS button
simultaneously for about 6 seconds until the online display on the headset starts to flash.
Your current software is then displayed on the base station.
The wireless light stands for RHL; the MUTE light for DHSG and the recharge display for AEI.
You can now switch between each software type with the PLUS and MINUS button.
To confirm the software setting, the device automatically switches to recharge again after 10 seconds.
The adjustment control (small wheel) on the base station must be set to "A".
Setting the transmission volume:
Please call someone with the headset on.
Now press the PLUS und MINUS button on the headset simultaneously, a signal tone will then sound.
You can now increase the microphone volume by pressing PLUS or lower it by pressing MINUS.
fter 15 seconds, a faint signal tone can be heard in the background confirming the change. The settings are then automatically saved.
Setting the Open Phone 63/65:
The telephone must be activated under "REMOTE HEADSET".
>Menu >Settings > Peripherals > Extra device selection > REMOTE HEADSET
(new setting on the device: DECT HEADSET)