How to connect Jabra my GN9330e with Nortel IP 1120E, 1140E, 1150E, 1165E

Prerequisite:

Jabra GN9330e + Jabra LINK 14201-32

In combination with one of the following phones:

• Nortel IP 1120E
• Nortel IP 1140E
• Nortel IP 1150E
• Nortel IP 1165E

from Firmware release 3.1 for IP phones

Connection:

1.  Connect the 1-sidedend (USB plug) of the EHS adapter to the USB socket of your phone set.
2.  Insert the RJ9 plug into the socket marked with a "phone" symbol and the RJ45 plug into the socket marked "AUX" on the base.

Software setup:

Put the headset into the base and activate "DHSG" mode.

Hold down the "phone" button on the base of the Jabra GN9330e for approx. 6 seconds until the online display (blue LED) on the headset starts to flash. The current software is displayed to you by activating the volume controller in the form of the charge display (yellow LED).

LEDs from left to right:

LED 1 = RHL
LED 2 = DHSG
LED 3 = AEI
LED 4 = MSH

Now you can switch between the different software modes (LED 1-4) by using the "volume" up/down controller on the headset. To confirm the software has successfully installed, the base automatically switches back to charge mode after approx. 15 seconds.

Base setup:

Set the phone set-up switch to "A".

Microphone level setup:

Please call someone with the headset.

If the other party cannot hear you well or just faintly, adjust the grey volume dial on the headset base until you can be understood clearly.

Headset answer/end:

As soon as the dial tone signal can be heard in the headset, you can answer the call by pressing the "answer/end" button on the headset; by pressing again the call is ended.

Phone setup:

Press the "Service" button twice > Preset >Headsets > USB 

In addition, you must activate the menu option "Enable HID Commands", see below.